Material: Steel
Thickness: 1/16"
This item is a piece of steel with cutouts and 90o bends in it.
As the piece faces you, with three of the four bends facing you
and one bend facing away from you, it consists of the following:
- A mounting side on the right, which is bent forward and has
  two finger tabs - one near the top outside corner and one at
  the bottom outside corner
- A back portion
- A tab on the top left, which is bent forward
  and provides a place to mount the plastic trigger
- A tab on the bottom left, which is bent back
  and has a squared cutout for the combination lock bolt
  to rest in when it is in the locked position. The square
  cutout continues into part of the back portion.
Height of lift: 4-5/16"
Right side mounting portions
  Top portion
    Height: 1-1/16"
    Depth: 1-1/16"
    Finger tab
      Width: 1/8"
      Length: 1/4"
  Bottom portion - is deeper at the top than the bottom
    Height: 1-21/32"
    Depth
      At top: 1-5/16"
      At bottom, where finger tab is: 1-1/16"
    Finger tab - goes to the right off the bottom portion
      then takes a 90o bend to point down
        Length of rightward portion
          At inside corner: 3/32"
          At outside corner: 1/4"
        Length of downward portion
          At inside corner: 3/32"
          At outside corner: 1/4"
Back portion
  Height: 4-5/16"
  Width
    At top, where top right portion and
      left plastic trigger mounting area is: 2-17/32"
    At middle: 1-3/8"
    At bottom, including lower right portion and
      left lock cutout tab: 1-19/32"
    At bottom, up to, but not including lock cutout: 1-1/6"
  Lock cutout
    Height: 7/8"
    Width: 7/16"
Left portions
  Top tab for plastic trigger mount
    Height: 1-1/16"
    Depth - top is narrower than the bottom
      At top: 5/8"
      At bottom: 1-3/16"
    Padlock hole
      Dia: 3/8"
      Distance to hole from bottom of tab: 3/16"
      Distance to hole from back of tab, where
        it joins the back plate: 11/16"
    There is a small finger tab that is lifted about 40o
      out of the surface of the left side fo this portion
      and goes in a direction of about a 2:00 position
      on a clodk as you face it. The plastic trigger
      snaps down over this finger.
        Width: 5/32"
        Length: 7/32"
        Height off surface: 1/8"
  Bottom tab with lock cutout
    Height
      Outside: 1-13/16"
      Inside: 7/8"
    Depth
      Outside: 23/32"
      Inside: 7/16"

Write a review today! » login required

Headline For example:
"I would buy this product again and again"
"Too much whiz and not enough bang"

Rating

Comments

Nickname

Location