Material: Black plastic
Height - there are four
  Front edge: 1-5/16"
  Concave curve witha a dime edge, just behind fron edge: 1-7/32"
  Long part near the back: 1-13/16"
  Very back, just behind a slot: 1-5/16"
Width: 7/16"
Dia of holes - there are two. Both go all the way from one side
  through to the other side of the trigger
    Padlock hole: 11/32"
    Hole tha snaps over finger tab on lift: 3/16"
Slots - there are three.
  One middle slot: runs from top to bottom and front to back,
    in line with, and through the middle of the tirgger (basically,
    the whole middle section is cut out). This slides over a portion
    of the lift. As you face each side:
      Height: 15/16"
      Depth: 3/32"
      Width: 1/16"
  The other two run vertically up and down the side of the
    trigger just behind the long portion. These fit down over
    and slide up and down the edges of the back cup slot when
    the lift is activated.
Mounting hardware: an aluminum pop rivet with steel mandrell,
  Mandrell
    Dia: 5/32"
    Length: 7/16"
  Head dia: 5/16"

Write a review today! » login required

Headline For example:
"I would buy this product again and again"
"Too much whiz and not enough bang"

Rating

Comments

Nickname

Location