Material
  Lift: Steel
  Trigger: Plastic
Thickness: 5/64" (between 1/16" and 3/32")
LIFT
  Back side
    Height: 4-1/4"
    Width of back plate (measurements taken from the back)
      At top: 2-3/32"
      At middle: 23/32"
      At bottom: 1-1/8"
    There is a tab at the bottom, which is bent to the back
      at a 90o angle
        Height: 21/32"
        Depth: 1/2"
  Side that mounts to the lockbar. There is a shorter front half
    and a taller back half, both, combined are the same height as
    the back of the lift.
      Front half
        Height, not including finger tab: 2-5/16"
        Width: 11/16"
        Finger tab (fits into lockbar)
        Height: 13/32"
        Width
          At the base: 5/32"
          At the tip: 9/64" (Between 1/8" and 5/32")
        The tab is bent out and up, to fit into a hole in the
          lockbar. The distance between inside of the tab
          and the outside wall of the lift
            At base of bend: 3/32"
            AT tip of finger: 1/8"
        Mounting hole
          Qty: 1
          Dia: 3/16"
          Distance from bottom of the lift to the center of
            the mounting hole: 9/32"
        The front half of the side fo the lift is offset to just
          outside the back half
            Offset amount: 1/16"
      Back half
        Height: 4-1/4"
        Depth: 21/32"
  Finger lift side
    Top portion - a horizontal tab
      Depth: 1-3/16"
      Height: 3/4"
    Lower portion - a tab that extends vertically down from
      the top portion. The PN-333T plastic trigger has a
      slot in it's middle which slides over and is mounted onto
      this portion.
        Depth: 3/4"
        Height: 9/16"
        Padkick hole dia: 3/8"
    Height of top and lower portions combined: 1-5/16"
Plastic trigger (PN-333T). The top third is wider than
  the lower two thirds. In addition, there is a rounded
  concave cutout at the bottom of the trigger, which has
  side-to-side grooves like the edge of a dime
    Height
      Upper portion: 7/16"
      Lower portion
        To the center: 3/4"
        To the outside edges: 7/8"
      Total height
        To the center of the cutout: 5/32"
        To the outside edges: 1-5/16"
    Depth
      Upper portion: 1-5/64" (BETWEEN 1-1/16" AND 1-3/32")
      Lower portion: 1-1/64"
    Thickness
      Upper portion: 9/16"
      Lower portion: 11/32"
    Padlock hole dia: 3/8"
    Mounting hole - has a round, recessed area on each side
      before the mounting hole starts
        Recess
          Dia: 5/16"
          Depth: 3/32"
        Mounting hole
          Dia: 1/8"
          Depth: 3/8"

Write a review today! » login required

Headline For example:
"I would buy this product again and again"
"Too much whiz and not enough bang"

Rating

Comments

Nickname

Location