MATERIAL
  BODY: CAST IRON
  ARM: FORGED STEEL (STRONGER THAN STAMPED STEEL)
  PINION: DOUBLE HEAT TREATED STEEL
FINISH: ALUMINUM
MOUNTING (BOLT) HOLES
  CLOSER BODY
    QTY: 2 ON TOP, 2 ON BOTTOM, 4 TOTAL
    HOLE TO HOLE OC
      SIDE TO SIDE: 6"
      TOP TO BOTTOM: 2-1/2"
  ARM
    QTY: 2 EACH ON TOP, 2 EACH ON BOTTOM, 4 TOTAL
    HOLE PATTERN: THE 2 ON TOP ARE CLOSER TOGETHER THAN
                   THE 2 ON BOTTOM
    HOLE TO HOLE OC
      TOP 2 HOLES: 2-1/8"
      BOTTOM 2 HOLES: 3-3/8"
      FROM TOP HOLES TO BOTTOM HOLES: 3/8"
PLACEMENT ON DOOR: PUSH SIDE (OPPOSITE OF HINGE SIDE)
DEGREE OF DOOR SWING: THIS COMES STANDARD WITH
  AN EDA (EXTRA DUTY) ARM. THE CUSTOMER CAN
  ADJUST HIS TEMPLATE FOR ANY OF THE FOLLOWING
  BEFORE HE INSTALLS IT ON THE DOOR:
  - 100o
  - 140o
  - 180o
CYLINDER SIZE: 4011
  THIS SIZE IS ADJUSTABLE FROM 1-5 AND IS SHIPPED SET TO SIZE 3.
  BECAUSE OF ITS SIZE RANGE, IT HANDLES A RANGE OF DOOR SIZES.
  - INTERIOR DOORS, FROM 28"-54"
  - EXTERIOR AND VESTIBULE DOORS, FROM 28"-48"
  - ADA DOORS, FROM 36"-48"*
  * THE MANUFACTURER NOTES THAT, WHILE THIS CLOSER IS TESTED AND
    CERTIFIED UNDER ANSI STANDARD A156.4, GRADE ONE, THAT ANY
    MANUAL DOOR CLOSER LIKE THIS ONE THAT IS SELECTED, INSTALLED,
    AND ADJUSTED BASED ON ADA OR OTHER REDUCED OPENING FORCE
    REQUIREMENTS MAY NOT PROVIDE SUFFICIENT POWER TO RELIABLY CLOSE
    AND LATCH A DOOR. THEY RECOMMEND A POWER OPERATOR INSTEAD.

Write a review today! » login required

Headline For example:
"I would buy this product again and again"
"Too much whiz and not enough bang"

Rating

Comments

Nickname

Location