How it works: This device has an inner shaft with a plunger handle
  on the top end and the ejector platform, which surrounds each
  tine, on the bottom end. This inner shaft rides back and forth in
  the outer shaft, to which the pull handle, tine platform and tines
  are attached. When the plunger shaft is pressed down, it moves
  the ejector platform down and out the entire length of the tines,
  removing anything attached to them.
Overall length: 41"
Material
  Main shaft and plunger shaft: Satin aluminum
  Tines and spring on handle: Stainless steel
  Grip handle, tines housing, ejector platform
    and tines protective cap: Orange plastic
Measurements are taken starting at the top of the device,
  which is the plunger, and working down to the tines:
Plunger on inner shaft
  Thickness: 3/16"
  Diameter at top: 1-1/4"
Inner aluminum shaft
  Overall length, including ejection platform: 38"
  Dia: 5/8"
Spring
  Wire dia: 3/64"
  Coils per inch: 4.8
Finger pulls on outer shaft
  Qty: One (1) on each side of shaft
  Width of one: 3/4"
  Width from tip of one pull to tip of other: 2-1/2"
  Distance from underside of pulls to
    top of plunger handle: 4-1/4"
Main shaft
  Length: 34"
  Dia: 7/8"
Tine housing
  Width: 1-1/2"
  Depth: 1-1/2"
  Overall height
    Including ejection platform: 1"
    Not including ejection platform: 5/8"
Tines
  Qty: 12
  Exposed length: 1-11/16"
  Dia: 3/32"
  Distance between tines: 5/16" and 1/2"
Ejection platform
  Height: 3/8"
  Width: 1-1/2"
  Depth: 1-1/2"
  Dia of holes for tines to pass through: 3/16"
  Ejection platform's length of travel down tines
    when plunger is depressed: 2-1/16"
Tines cap
  Height
    Inside: 2-5/16"
    Outside: 2-3/8"
  Diameter
    Upper portion: 2-3/8"
    Lower portion: 1-19/32"
  Material thickness: 1/8"

Write a review today! » login required

Headline For example:
"I would buy this product again and again"
"Too much whiz and not enough bang"

Rating

Comments

Nickname

Location